It is possible to use.

The kit includes six types of tip shape drivers, and it can be used for many implant manufacturers' systems.

It can be used.

Depending on the condition in the oral cavity and conditions, because it is designed to have a short total length, it is possible to correspond to some molars.

Each kit including the case can be sterilized. Autoclave (high pressure steam sterilization) is suitable.

The warranty period of the product is not established.

We have set parts only for O ring.

It becomes a device to tighten the torque manually.

It will be possible. It is out of warranty.

Six types of drivers are set as options. Handpiece drivers can be used with adapters.

It is a torque driver for dental technicians. Can not be used in the oral cavity because sterilization is impossible.

Prepare an optional wrench adapter. Then it can be applied to many manufacturers. Because the handpiece driver of each implant system can be installed.

It is set from various factors. If it is loose, it is easy to loosen due to shaking or the like. Also, if you tighten it too tightly, there is also risk of re-treatment.

The advantage is that you can quantify the degree of digital tightening by CAD / CAM. The quality is considered to be stable.

The lower limit setting is 6cNm and the upper limit is 60cNm.

Dental technicians are generally said to be adjusted around 15cN·m in many cases.

You can do it by changing from preset mode to measurement mode. At that time, the sound (beep) does not sound.

It's sterilization becomes impossible. Because for dental technicians use.

Product inspection and confirmation are available only in Japan.

Please contact the electronics store etc. The battery standard is CR2354 (coin type lithium battery).

We have published it in the catalog or instruction manual. It is about 1 month (when 100 times / day is used), but it may be shorter depending on usage situation and environment. Be sure to prepare spare batteries.

We have set only a part, please contact the manufacturer for details.

Pull out the insulating sheet. Please replace the battery first. Also press the power button for about 1 second.

In the case of E1 to E7 display, turn off the power supply and restart it.

It is possible to use.

Set the wrench adapter to use the contra handpiece driver. This makes it possible to attach a driver for handpiece and it is possible to correspond to many implant sistem.

It can be used.

Depending on the patient, it is possible to correspond to some molars.

It is set from various factors. If it is loose, it is easy to loosen due to shaking or the like. Also, if you tighten it too tightly, there is also risk of re-treatment.

The tightened torque value is displayed accurately on the needle. Accurate treatment is possible by implant, tightening of the abutment and so on.

It is possible to accurately display the small torque value. Measuring fastening torque of the prostheticis main. When it exceeds the limit torque value, it also has an adverse effect on the bone, so it is not effective.

When tightening a prosthetic material manufactured at a dental laboratory, you can use it without worrying about the difference in usability. Measurement error is small because it uses the same instrument as the doctor.

The sterilizable part is a wrench. Autoclave (high pressure steam sterilization) is suitable.

After surgery, separate the adapter from the body, rinse with water or a small amount of neutral detergent, please wash. In the case of automatic cleaning, use an ultrasonic cleaner and an appropriate cleaning solution, and after washing wipe off moisture and dry.

Please disassemble and clean the head part of the wrench based on the package insert.

Product inspection and confirmation are available only in Japan.

The warranty period of the product is not established.

There is no setting. The reason is to maintain accuracy.

Disassemble gear and lid, perform ultrasonic cleaning, reassemble and check again. Please lubricate the contra oil spray for about 1 second and wipe off extra oil.

There is a possibility of a difference in the assembling position of the component parts inside the wrench. Please change the position and reassemble.